Non-combustible, insulating, triple clamps (braces) holders for po 3 number of cells lithium ion battery type 18650.
They are needed when making a package of batteries with spot welding or soldering, to ensure the mechanical strength of the package and for its more convenient construction.
They do not allow cell displacement, detachment of welds or solders by vibration, shocks and other mechanical impacts.
The brackets allow a small air gap between the cells, which allows good cooling of the battery pack.
The clamps are sized to run a spot welding rail up to 8 mm and are standard.
Most type 2s rails, 3S, 4S, 5S, 6S, 7S, 8S, 9S, 10S, 13S, 14S, 16S, 20S etc.. lie in their intended slot (rail).
The brackets are assembled with each other, pinching along the designated channels.
Each bracket is with 3 sockets for one battery 18650.
Dimensions: 6 x 2 x 0.8cm / 2.36″ x 0.79″ x 0.31″
The outer diameter of the bracket hole is 20.2 mm, which is standard.
They are needed when making a package of batteries with spot welding or soldering, to ensure the mechanical strength of the package and for its more convenient construction.
They do not allow cell displacement, detachment of welds or solders by vibration, shocks and other mechanical impacts.
The brackets allow a small air gap between the cells, which allows good cooling of the battery pack.
The clamps are sized to run a spot welding rail up to 8 mm and are standard.
Most type 2s rails, 3S, 4S, 5S, 6S, 7S, 8S, 9S, 10S, 13S, 14S, 16S, 20S etc.. lie in their intended slot (rail).
The brackets are assembled with each other, pinching along the designated channels.
Each bracket is with 3 sockets for one battery 18650.
Dimensions: 6 x 2 x 0.8cm / 2.36″ x 0.79″ x 0.31″
The outer diameter of the bracket hole is 20.2 mm, which is standard.
Reviews
There are no reviews yet.